Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC) › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049571 YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR(for 4WD/AWD without VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 4.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 89189B 5.REMOVE YAW RATE SENSOR BRACKET

a.
C274706

Remove the bolt and yaw rate sensor bracket.


Hide 89441A 6.REMOVE DECELERATION SENSOR

a.
C191841

Disconnect the deceleration sensor connector.


b.

Remove the 2 bolts and deceleration sensor.

NOTICE:

Do not remove the sensor from the bracket.