Home › Power Source / Network › 2AD-FHV BATTERY / CHARGING › BATTERY CURRENT SENSOR
RM3090E _57 Power Source / Network _008778 2AD-FHV BATTERY / CHARGING _0049602 BATTERY CURRENT SENSOR A

2AD-FHV BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850 1.INSTALL BATTERY CURRENT SENSOR ASSEMBLY

a.

Install the battery current sensor assembly to the No. 3 engine wire.


b.

Connect the connector to the battery current sensor assembly.


c.

Install the No. 3 engine wire and battery current sensor assembly to the negative (-) battery terminal with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


d.

Connect the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION