Home › Engine / Hybrid System › STOP AND START › ENGINE STOP AND START ECU › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _009049 STOP AND START _0049620 ENGINE STOP AND START ECU A

STOP AND START  ENGINE STOP AND START ECU  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55607 4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55550 5.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 82877 6.REMOVE ECU INTEGRATION BOX RH (for LHD)

A346080C01
1.063,0.031 1.292,0.219 0.229,0.188 10 true *1 0.49,1.719 0.698,1.917 0.208,0.198 10 true *2 2.646,0.031 2.875,0.219 0.229,0.188 10 true *1
*1 Nut
*2 Bolt


a.

Disconnect each connector and clamp.


b.

Remove the 2 nuts, bolt and ECU integration box RH.


Hide 89261A 7.REMOVE ENGINE STOP AND START ECU (for LHD)

A273341

a.

Disengage the 2 claws and remove the engine stop and start ECU from the ECU integration box RH.


Hide 89261A 8.REMOVE ENGINE STOP AND START ECU (for RHD)

a.
A273342C01
1.115,0.042 1.302,0.208 0.188,0.167 10 true *1 0.969,1.99 1.156,2.156 0.188,0.167 10 true *2
*1 Nut
*2 Bolt


Disconnect the 3 connectors from the engine stop and start ECU.


b.

Remove the bolt, nut and engine stop and start ECU.