Home › Engine / Hybrid System › 1AD-FTV STARTING › GLOW PLUG CONTROLLER › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0049647 GLOW PLUG CONTROLLER A

1AD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53876A 3.REMOVE FRONT FENDER LINER LH

a.

Partially remove the front fender liner LH.

HINT:

It is not necessary to fully remove the front fender liner LH.

Partially remove it so that the glow plug controller assembly can be removed.



Hide 28551 4.REMOVE GLOW PLUG CONTROLLER ASSEMBLY

a.
A291370

Disconnect the 4 glow plug controller connectors.


b.

Remove the 2 bolts and glow plug controller assembly.


Hide 28559 5.REMOVE GLOW PLUG CONTROLLER BRACKET

a.
A297135

Remove the 4 screws and 2 glow plug controller brackets from the glow plug controller.