Home › Engine / Hybrid System › 1AD-FTV STARTING › GLOW PLUG › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0049650 GLOW PLUG G

1AD-FTV STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 19871 1.REMOVE NO. 1 GLOW PLUG CONNECTOR

Hide 19850 2.INSPECT GLOW PLUG ASSEMBLY

a.
A297109

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug terminal - Body ground 20°C (68°F) 0.28 Ω or higher


If the result is not as specified, replace the glow plug assembly.

NOTICE:
·

Be careful not to damage the glow plug assembly as this may cause an open circuit or shorten the life of the glow plugs.

·

Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.

·

Clean any oil on the terminal and bakelite washer with a dry cloth.




Hide 19871 3.INSTALL NO. 1 GLOW PLUG CONNECTOR