Home › Engine / Hybrid System › 1AD-FTV STARTING › GLOW PLUG › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0049650 GLOW PLUG A

1AD-FTV STARTING  GLOW PLUG  INSTALLATION  


PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.
A291462C01
1.583,2.5 1.75,2.5 1.75,2.5 1.927,3.042 true 0.333,2.5 0.5,2.5 0.5,2.5 0.667,3 true 0.188,2.406 0.5,2.563 0.313,0.156 10 false *1 1.427,2.406 1.74,2.563 0.313,0.156 10 false *2
*1 Color (White)
*2 Mark (7V)


Check the insulator color and the mark on each glow plug, and then, using a 10 mm deep socket wrench, install the 4 glow plugs.

Torque:
12 N*m (125 kgf*cm, 9 ft.*lbf)

NOTICE:

As the engine may be damaged, do not install any glow plug other than the type indicated in the illustration.



Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the No. 1 glow plug connector with the 4 nuts.

Torque:
2.2 N*m (22 kgf*cm, 19 in.*lbf)


b.

Attach the clamp and connect the glow plug connector to the bracket.


c.

Install the 4 screw grommets.


Hide 12631A 3.INSTALL ENGINE COVER BRACKET

a.
A291391C01
0.26,1.052 0.469,1.24 0.208,0.188 10 A 1.49,1.833 1.698,2.021 0.208,0.188 10 B

Temporarily install the engine wire with the bolt labeled A in the illustration.


b.

Temporarily install the engine cover bracket with the nut and the bolt labeled B in the illustration.


c.

Tighten the 2 bolts and nut.

Torque:
for bolt A : 8.4 N*m (86 kgf*cm, 74 in.*lbf)
for bolt B : 20 N*m (204 kgf*cm, 15 ft.*lbf)
for nut : 8.4 N*m (86 kgf*cm, 74 in.*lbf)


d.

Connect the glow plug connector.


Hide 25602 4.INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION