Home › Engine / Hybrid System › 2AD-FTV FUEL › COMMON RAIL
RM3090E _51 Engine / Hybrid System _008735 2AD-FTV FUEL _0049726 COMMON RAIL A

2AD-FTV FUEL  COMMON RAIL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injector assemblies (including shuffling the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82121 4.DISCONNECT ENGINE WIRE

Hide 5.REMOVE INJECTION PIPE SUB-ASSEMBLY

Hide 23804C 6.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

Hide 23810A 7.REMOVE COMMON RAIL ASSEMBLY

a.
A271583

Slide the clamp and disconnect the No. 4 fuel hose from the common rail assembly.


b.

Remove the 2 bolts and common rail assembly.