19850
1.INSTALL GLOW PLUG ASSEMBLY
| *1 | Color (Red) |
| *2 | Mark (11V) |
Check the insulator color and the mark on each glow plug assembly, and then , using a 10 mm deep socket wrench, install the 4 glow plugs.
As the engine may be damaged, do not inatall any glow plug assembly other than the type indicated in the illustration.
19871
2.INSTALL NO. 1 GLOW PLUG CONNECTOR
Install the glow plug connector with the 4 nuts.
Connect the wire harness with the nut.
Install the 5 screw grommets.
12631A
3.INSTALL ENGINE COVER BRACKET
Temporarily install the engine wire with the bolt labeled A in the illustration.
Temporarily install the engine cover bracket with the nut and bolt labeled B in the illustration.
Tighten the 2 bolts and nut.
25602
4.INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY
12611
5.INSTALL NO. 1 ENGINE COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION