Home › Engine / Hybrid System › 2AD-FHV STARTING › GLOW PLUG
RM3090E _51 Engine / Hybrid System _008739 2AD-FHV STARTING _0049806 GLOW PLUG A

2AD-FHV STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 25602 4.REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY

Hide 12631A 5.REMOVE ENGINE COVER BRACKET

a.
A291363

Remove the bolt, nut and engine cover bracket.


b.

Remove the bolt and disconnect the engine wire so that the glow plugs can be removed in a later step.


Hide 19871 6.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.
A267457

Remove the 5 screw grommets.


b.
A300819C02
0.552,0.969 0.552,0.823 0.552,0.823 0.854,0.635 false 0.469,0.99 0.781,1.146 0.313,0.156 10 *1
*1 Wire Harness


Remove the nut and disconnect the wire harness.


c.

Remove the 4 nuts and No. 1 glow plug connector.


Hide 19850 7.REMOVE GLOW PLUG ASSEMBLY

a.
A209801

Using a 10 mm deep socket wrench, remove the 4 glow plugs.