Home › Engine / Hybrid System › 2AD-FTV STARTING › GLOW PLUG
RM3090E _51 Engine / Hybrid System _008741 2AD-FTV STARTING _0049817 GLOW PLUG A

2AD-FTV STARTING  GLOW PLUG  INSTALLATION  


PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.
A265529C03
1.886,3.025 1.6,2.499 1.6,2.499 1.506,2.499 false 1.31,2.416 1.481,2.576 0.171,0.161 10 *2 0.664,2.993 0.397,2.499 0.397,2.499 0.303,2.499 false 0.112,2.416 0.283,2.576 0.171,0.161 10 *1
*1 Color (Red)
*2 Mark (11V)


Check the insulator color and the mark on each glow plug assembly, and then, using a 10 mm deep socket wrench, install the 4 glow plugs.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:

As the engine may be damaged, do not install any glow plug assembly other than the type indicated in the illustration.



Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the No. 1 glow plug connector with the 4 nuts.

Torque:
2.2 N*m (22 kgf*cm, 19 in.*lbf)


b.

Connect the wire harness with the nut.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


c.

Install the 5 screw grommets.


Hide 12631A 3.INSTALL ENGINE COVER BRACKET

a.
A300068N01
0.229,1.083 0.385,1.281 0.156,0.198 10 A 1.51,1.865 1.667,2.063 0.156,0.198 10 B

Temporarily install the engine wire with the bolt labeled A in the illustration.


b.

Temporarily install the engine cover bracket with the nut and bolt labeled B in the illustration.


c.

Tighten the 2 bolts and nut.

Torque:
for bolt A : 8.4 N*m (86 kgf*cm, 74 in.*lbf)
for bolt B : 20 N*m (204 kgf*cm, 15 ft.*lbf)
for nut : 8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 25602 4.INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION