Home › Engine / Hybrid System › 2AD-FTV STARTING › STARTER
RM3090E _51 Engine / Hybrid System _008741 2AD-FTV STARTING _0049818 STARTER A

2AD-FTV STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 5.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 74404A 6.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28899 7.REMOVE BATTERY INSULATOR

Hide 28800 8.REMOVE BATTERY

Hide 74431 9.REMOVE BATTERY TRAY

Hide 74417 10.REMOVE FRONT BATTERY BRACKET

Hide 74414B 11.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 17705 12.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 13.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17769 15.REMOVE AIR CLEANER SUPPORT

Hide 16.DISCONNECT FUEL FILTER ASSEMBLY

a.
A291381

Remove the bolt and disconnect the fuel filter assembly.


Hide 17119A 17.REMOVE AIR CLEANER BRACKET

Hide 17361J 18.REMOVE NO. 1 AIR TUBE

a.
A299945C01
0.063,0.083 0.375,0.24 0.313,0.156 10 *A 0.115,2.302 0.427,2.458 0.313,0.156 10 *B
*A for Manual Transaxle
*B for Automatic Transaxle


Remove the bolt and detach the wire harness clamp.


b.
A299946C01
0.083,0.104 0.396,0.26 0.313,0.156 10 *A 0.156,2.281 0.469,2.438 0.313,0.156 10 *B
*A for Manual Transaxle
*B for Automatic Transaxle


Detach the 2 wire harness clamps.


c.
A300213C01
0.24,0.302 0.552,0.458 0.313,0.156 10 *A 0.229,2.708 0.542,2.865 0.313,0.156 10 *B
*A for Manual Transaxle
*B for Automatic Transaxle


Remove the 2 bolts and loosen the 2 clamps.


d.

Remove the No. 1 air tube.


Hide 28100 20.REMOVE STARTER ASSEMBLY

a.
A163980

Disconnect the starter connector.


b.

Open the terminal cap, remove the nut and disconnect the starter wire.


c.
A301338

Remove the 2 bolts and starter assembly.