Home › Engine / Hybrid System › 2AD-FHV FUEL › COMMON RAIL
RM3090E _51 Engine / Hybrid System _008734 2AD-FHV FUEL _0049857 COMMON RAIL A

2AD-FHV FUEL  COMMON RAIL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injector assemblies (including shuffling the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.



PROCEDURE

Hide 23810A 1.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail sub-assembly with the 2 bolts.

Torque:
21 N*m (209 kgf*cm, 15 ft.*lbf)


b.

Connect the No. 4 fuel hose to the common rail assembly, and slide the clamp to secure it.


Hide 2.INSTALL INJECTION PIPE SUB-ASSEMBLY

Hide 23804C 3.INSTALL FUEL INLET PIPE SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION