When replacing the injector assemblies (including shuffling the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12611
3.REMOVE NO. 1 ENGINE COVER
82121
4.DISCONNECT ENGINE WIRE
5.REMOVE INJECTION PIPE SUB-ASSEMBLY
23804C
6.REMOVE FUEL INLET PIPE SUB-ASSEMBLY
23810A
7.REMOVE COMMON RAIL ASSEMBLY
Slide the clamp and disconnect the No. 4 fuel hose from the common rail assembly.
Remove the 2 bolts and common rail assembly.