Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER › 2012.12–2013.11
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0049871 REAR DOOR SPEAKER A

AUDIO / VIDEO  REAR DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74646 2.REMOVE DOOR ASSIST GRIP COVER LH

Hide 69284D 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67604 4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 86160B 5.REMOVE REAR SPEAKER ASSEMBLY

NOTICE:

Do not touch the cone part of the speaker.


a.
B335798N01
2.104,0.365 2.26,0.563 0.156,0.198 10 a

Disconnect the connector.


b.

Put a 5 mm (0.197 in.) drill bit into a drill.


c.

Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

NOTICE:

Tape the 5 mm (0.197 in.) drill bit to prevent the drill bit from going to deep.


Standard:
Area Specified Condition
a 4 mm (0.157 in.)



d.

Lightly press the drill against the 3 rivets, drill off the flanges of the 3 rivets and remove the rear speaker assembly.

CAUTION:

Be careful of the drilled rivet as it may become hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.




e.

Continue drilling and push out the remaining rivet fragments.


f.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.