Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM3090E _58 Vehicle Interior _008782 DOOR LOCK _0049894 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69060A 3.INSTALL REAR DOOR WITH MOTOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to contact the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.



a.

Apply MP grease to the sliding parts of the rear door with motor lock assembly LH.


b.
B337024

Install a new door lock wiring harness seal to the rear door with motor lock assembly LH.


c.
B337027C01
1.396,0.969 1.615,1.125 0.219,0.156 10 true *a
*a Upward


Insert the rear door with motor lock assembly LH into the rear door outside handle frame release plate, and set it to the rear door panel.


d.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door with motor lock assembly LH.


e.
B337022C01
0.021,0.01 0.333,0.167 0.313,0.156 10 *A 0.021,1.76 0.333,1.917 0.313,0.156 10 *B
*A w/o Double Locking System
*B w/ Double Locking System


Using a T30 "TORX" socket wrench, install the rear door with motor lock assembly LH with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Connect the connector.


Hide 68152C 4.INSTALL REAR DOOR GLASS RUN LH

Hide 68104 5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124B 6.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408E 7.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 67604 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69284D 10.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 74646A 11.INSTALL DOOR ASSIST GRIP COVER LH

Hide 12.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 15.CHECK POWER DOOR LOCK CONTROL SYSTEM