Home › Engine / Hybrid System › 1AD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2012.12–2013.11
RM3090E _51 Engine / Hybrid System _008733 1AD-FTV ENGINE MECHANICAL _0049955 REAR CRANKSHAFT OIL SEAL A

1AD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 31210 4.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 5.REMOVE CLUTCH DISC ASSEMBLY

Hide 13450 6.REMOVE FLYWHEEL WITH DAMPER ASSEMBLY

Hide 11401L 7.REMOVE REAR ENGINE OIL SEAL

a.
A298082C04
0.438,1.865 0.438,1.74 false 0.438,1.802 1.021,1.917 1.021,1.917 1.198,1.781 false 2.448,0.99 2.792,0.323 2.792,0.323 2.948,0.323 true 1.563,0.125 1.875,0.323 0.313,0.198 10 false *1 0.958,1.938 1.271,2.135 0.313,0.198 10 false *1 2.979,0.229 3.292,0.385 0.313,0.156 10 false *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver, pry out the rear engine oil seal.

NOTICE:
·

Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

·

After removing the rear engine oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.