Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM(for 1AD-FTV) › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _009049 STOP AND START _0049492 STOP AND START SYSTEM(for 1AD-FTV) J

STOP AND START  STOP AND START SYSTEM(for 1AD-FTV)  Stop and Start System does not Operate (During PM Regeneration)  


DESCRIPTION

Check whether stop and start control is prohibited based on the PM regeneration conditions.

HINT:

Stop and start control is prohibited when the DPF warning light is illuminated (PM accumulation is close to the limit)

(Normally, the stop and start control is permitted during PM regeneration)


PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (DPF WARNING LIGHT)
a.

Check the illumination condition of the DPF warning light.

Result:
Proceed to
Not illuminated
Illuminated




Not illuminated

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Illuminated

END (DRIVE VEHICLE UNTIL PM REGENERATION IS COMPLETE)