Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM(for 1AD-FTV) › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _009049 STOP AND START _0049492 STOP AND START SYSTEM(for 1AD-FTV) T

STOP AND START  STOP AND START SYSTEM(for 1AD-FTV)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Stop and Start System
Symptom Suspected Area Link
Stop and start system does not operate Stop and start system operation prohibition based on the battery conditions (Refer to "Stop and Start System does not Operate (Battery Condition)") Click here
Stop and start system operation prohibition based on the PM regeneration conditions (Refer to "Stop and Start System does not Operate (During PM Regeneration)") Click here
Engine hood courtesy switch circuit Click here
Driver door courtesy switch circuit (system prohibits control) Click here
Driver door courtesy switch circuit (CAN communication DTC U0140) Click here
Driver door courtesy switch circuit Click here
Driver seat belt buckle switch circuit (system prohibits control) Click here
Driver seat belt buckle switch circuit (CAN communication DTC U0140) Click here
Front seat inner belt assembly (for driver side) Click here
Air conditioning system (system prohibits control) Click here
Air conditioning system (for Automatic Air Conditioning System) Click here
Air conditioning system (for Manual Air Conditioning System) Click here
Brake booster vacuum is low (system prohibits control) Click here
Brake booster vacuum is low Click here
Backup boost converter circuit Click here
Neutral position switch circuit Click here
Crankshaft position sensor Click here
ECM Click here
Vacuum sensor assembly Click here
Brake booster assembly (for LHD) Click here
Brake booster assembly (for RHD) Click here
Starter assembly Click here
The deceleration sensor zero point calibration is performed Click here
Deceleration sensor (airbag sensor assembly) Click here
Skid control ECU (brake actuator assembly) Click here
CAN communication system (for LHD) Click here
CAN communication system (for RHD) Click here
Engine stop and start ECU Click here
Battery* Click here
Wire harness or connector -
Stop and start cancel indicator light does not operate Combination meter assembly Click here
Indicator circuit (CAN communication DTC U0155) Click here
Engine stop and start ECU Click here
Stop and start indicator light does not operate Combination meter assembly Click here
Indicator circuit (CAN communication DTC U0155) Click here
Engine stop and start ECU Click here
Stop and start control cannot be canceled Stop and start cancel switch circuit Click here
ECAN terminal voltage Click here
Stop and start system cancel switch (combination switch assembly) Click here
The engine is not stopped by stop and start control (stop and start operation is prohibited) The shift lever is operated without depressing the clutch pedal (system operation prohibition) Click here
Engine hood courtesy switch circuit Click here
Driver side door courtesy switch circuit Click here
Stop light switch assembly Click here
Clutch start switch assembly (for lower) Click here
Clutch switch assembly (for upper) Click here
Engine stop and start ECU Click here

*: If the vehicle has not been driven for a long time, the battery charge will be low and stop and start control operation will be prohibited. In this case, recharge the battery, initialize the integrated current value* and drive the vehicle until stop and start control operation is permitted (approximately 15 to 40 minutes).

*: Disconnect the cables from the battery, wait for 30 seconds or more and then reconnect the cables.


HINT:

When the cable is disconnected from the negative (-) battery terminal, stop and start control is prohibited for a certain amount of time. After connecting the cable, drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes).