Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0050034 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E261004C02
2.24,2.542 2.135,2.198 false 2.635,2.344 2.333,2.25 false 2.542,0.688 2.354,0.323 false 2.844,0.688 3.052,0.5 false 2.26,0.198 2.417,0.396 0.156,0.198 10 false a 3.083,0.396 3.24,0.594 0.156,0.198 10 false b 2.667,0.208 2.823,0.406 0.156,0.198 10 false X 1.573,1.417 1.729,1.615 0.156,0.198 10 false A 1.573,1.688 1.729,1.885 0.156,0.198 10 false B 0.792,2.458 0.948,2.656 0.156,0.198 10 false C 2.188,2.531 2.417,2.729 0.229,0.198 10 true *a 2.656,2.271 2.865,2.469 0.208,0.198 10 true *b
*a Secured Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Mark Measurement
A 34.3 mm (1.35 in.)
B 20.9 mm (0.823 in.)
C 48 to 52 mm (1.89 to 2.04 in.)


NOTICE:
·

Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the thermistor, do not apply excessive force to the wire.

·

Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 88515 3.INSTALL COOLER EXPANSION VALVE

Hide 87050 4.INSTALL AIR CONDITIONING RADIATOR ASSEMBLY