Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050101 HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight) A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81110L 1.INSTALL DISCHARGE HEADLIGHT BULB

E268998N01
1.188,0.25 1.646,0.448 0.458,0.198 10 (1) 2.198,0.865 2.656,1.063 0.458,0.198 10 (2) 0.365,0.958 0.823,1.156 0.458,0.198 10 (2)

a.

Set the discharge headlight bulb to the headlight unit.


b.

Lock the set spring in the order shown in the illustration to install the discharge headlight bulb to the headlight unit.

NOTICE:

Do not touch the discharge headlight bulb glass.



Hide 81134 2.INSTALL HEADLIGHT GASKET

a.

Install a new headlight gasket to the headlight light control ECU sub-assembly.


Hide 81107 3.INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

a.
E268996

Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly socket.

NOTICE:
·

Check that the headlight gasket is installed on the headlight light control ECU sub-assembly.

·

Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

·

Do not pull the headlight light control ECU sub-assembly with the socket connected.




b.
E268994

Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to install the headlight light control ECU sub-assembly to the headlight unit.


c.

Connect the connector.


d.

for RHD:

Install the washer tank with the clip.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION