Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050101 HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight) A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 81107 3.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

a.

for RH Side:

i.
E268991

Remove the clip.


ii.
E268992

Move the washer tank as shown in the illustration.



b.
E268993

Disconnect the connector.


c.

Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to separate the headlight light control ECU sub-assembly from the headlight unit.

NOTICE:
·

Do not apply excessive force using a tool.

·

Do not damage the headlight gasket or allow it to become contaminated with foreign matter. If the headlight gasket is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.




d.
E268995

Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to remove the headlight light control ECU sub-assembly.

NOTICE:

Do not pull the headlight light control ECU sub-assembly with the socket connected.



Hide 81134 4.REMOVE HEADLIGHT GASKET

a.
E268999

Remove the headlight gasket from the headlight light control ECU sub-assembly.


Hide 81110L 5.REMOVE DISCHARGE HEADLIGHT BULB

a.
E268997N01
2.177,1.208 2.635,1.406 0.458,0.198 10 (1) 1.219,1.667 1.677,1.865 0.458,0.198 10 (2) 0.427,1.302 0.885,1.5 0.458,0.198 10 (1)

Release the set spring lock in the order shown in the illustration and remove the discharge headlight bulb.

NOTICE:

Do not touch the discharge headlight bulb glass.