Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050118 HEADLIGHT LEVELING ECU A

LIGHTING (EXT)  HEADLIGHT LEVELING ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55312 4.REMOVE LOWER INSTRUMENT PANEL

Hide 89960 5.REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

E269027

a.

Disconnect the connector.


b.

Remove the bolt and headlight leveling ECU assembly.