Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY(for HID Headlight) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050130 HEADLIGHT ASSEMBLY(for HID Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for HID Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 52119A 3.REMOVE FRONT BUMPER COVER

Hide 4.REMOVE HEADLIGHT ASSEMBLY LH

E268969C03
3.135,1.583 2.865,1.438 false 3.167,1.531 3.396,1.677 0.229,0.146 10 false *1 2.906,0.104 3.219,0.26 0.313,0.156 10 false *3 2.885,2.406 3.198,2.563 0.313,0.156 10 false *2 1.708,0.448 2.021,0.604 0.313,0.156 10 false *3 0.698,0.458 1.01,0.615 0.313,0.156 10 false *3
*1 Protective Tape
*2 Bolt
*3 Screw


a.

Put protective tape around the headlight assembly LH.


b.

Remove the bolt and 3 screws.


c.

Disconnect each connector to remove the headlight assembly LH.