Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › 4WD CONTROL ECU
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0050210 4WD CONTROL ECU A

GF1A TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 55870B 5.REMOVE HEATER TO REGISTER DUCT ASSEMBLY

Hide 89630A 6.REMOVE 4WD ECU ASSEMBLY

C278887

a.

Disconnect the connector.


b.

Remove the bolt and 4WD ECU assembly.