89871A
1.REMOVE INJECTOR DRIVER
85110
2.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
55701J
3.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
17769
4.REMOVE AIR CLEANER SUPPORT
55736D
5.REMOVE COWL BODY MOUNTING REINFORCEMENT LH
Remove the 2 nuts and mounting reinforcement.
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Driver Side Knee Airbag)
55432B
7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)
73900
8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
9.DRAIN BRAKE FLUID
Wash brake fluid off immediately if it adheres to any painted surface.
31434
10.DISCONNECT CLUTCH RESERVOIR TUBE
Slide the clamp and disconnect the tube from the clutch master cylinder.
Use a container to catch the fluid.
31481
11.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.
Use a container to catch the fluid.
31453A
12.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
31410
13.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
Remove the 2 nuts and clutch master cylinder assembly.
31459
14.REMOVE CLUTCH MASTER CYLINDER BRACKET
Remove the clutch master cylinder bracket from the clutch master cylinder assembly.
31453
15.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
| *1 | Lock Nut |
| *2 | Clutch Master Cylinder Push Rod Clevis |
Measure dimension A as shown in the illustration before loosening the lock nut.
Loosen the lock nut and remove the clutch master cylinder push rod clevis.
Remove the lock nut.