Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL
73240
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
Disconnect each connector and each clamp.
Fold up the separate type front seat cushion cover.
Remove the nut and front seat inner belt assembly.
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
w/o Occupant Detection ECU:
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>REMOVAL
w/ Occupant Detection ECU:
Using moulding remover A, detach the 2 claws and 2 guides to remove the front seat cushion shield RH.
Disconnect each connector and each clamp.
Fold up the separate type front seat cushion cover.
Remove the screw.
Detach the guide to remove the limit switch of the front seat inner belt assembly.
Remove the nut and front seat inner belt assembly.