Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH(for RHD) › 2012.12–2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0050342 BLIND SPOT MONITOR MAIN SWITCH(for RHD) A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR MAIN SWITCH(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time maybe required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55412C 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 83950M 4.REMOVE TELLTALE LIGHT ASSEMBLY (BLIND SPOT MONITOR MAIN SWITCH)

a.
B337767

Detach the 2 clips and claw and remove the telltale light assembly (blind spot monitor main switch).


b.
B337768

Disconnect the connector.