Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM3090E _58 Vehicle Interior _008788 SEAT BELT _0050356 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL


Hide 72525A 2.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

a.
B334866C01
0.75,0.417 0.917,0.417 0.917,0.417 1.167,0.583 false 0.583,0.333 0.896,0.531 0.313,0.198 10 *1
*1 Protective Tape


Raise the reclining adjuster release handle RH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle RH.

HINT:

Tape the screwdriver tip before use.



Hide 71811D 3.REMOVE FRONT SEAT CUSHION SHIELD RH

a.
B334867

Disconnect the rubber band of the separate type front seatback cover from the separate type front seat cushion spring assembly.


b.
B334868

Detach the 2 claws, 4 guides and 2 clips to remove the front seat cushion shield RH.


Hide 73230 4.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>REMOVAL


Hide 71861 5.REMOVE FRONT SEAT INNER CUSHION SHIELD RH

a.
B334869

Detach the 2 claws and 2 guides to remove the front seat inner cushion shield RH.


Hide 6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

a.
B334870C01
2.219,2.635 2.76,2.469 true 2.792,2.385 3.104,2.583 0.313,0.198 10 *1
*1 Fastener


Detach the claw and 4 clamps to disconnect the front seat airbag assembly wire harness from the separate type front seat cushion spring assembly.


b.

Detach the fastener to disconnect the front seat airbag assembly wire harness from the separate type front seat cushion cover.


c.

w/ Seat Heater System:

Disconnect each connector and each clamp.


d.
B334871

Detach the 2 hooks of the separate type front seat cushion cover from the separate type front seatback assembly.


e.
B334872

Remove the 4 bolts and separate type front seatback assembly.


Hide 7.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

a.

Detach the 11 hooks.

B334873


b.
B334874

Detach the claw to disconnect the occupant detection sensor connector and remove the separate type front seat cushion cover with pad from the separate type front seat cushion spring assembly.


Hide 71511S 8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)

a.

Remove the 21 hog rings and separate type front seat cushion pad (occupant detection sensor) from the separate type front seat cushion cover.

B334875