Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › INTRUSION SENSOR › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0050372 INTRUSION SENSOR A

THEFT DETERRENT / KEYLESS ENTRY  INTRUSION SENSOR  INSTALLATION  


PROCEDURE

Hide 89732 1.INSTALL THEFT WARNING RADAR SENSOR

a.

Install the theft warning radar sensor with the 4 screws.


b.

w/ Sliding Roof:

i.

Attach the 2 claws and install the overhead junction block assembly.


ii.

Install the 6 screws.



c.

w/o Sliding Roof:

i.

Attach the 2 claws and install the overhead junction block assembly.


ii.

Install the 5 screws.



d.

w/ Sliding Roof:

i.

Connect the connectors.


ii.

Attach the 2 clamps and install the 2 screws.



e.

w/o Sliding Roof:

i.

Connect the connectors.


ii.

Attach the 3 clamps and install the 2 screws.



Hide 86250E 2.INSTALL AMPLIFIER MICROPHONE ASSEMBLY

Hide 81260A 3.INSTALL MAP LIGHT ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION