This DTC is output when the multiplex network door ECU detects a power back door unit assembly set RH motor malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2229 | PBD Unit Motor RH Circuit | This DTC is output when the multiplex network door ECU detects a power back door unit assembly set RH motor malfunction. | ·
Multiplex network door ECU ·
Power back door unit assembly set RH ·
Harness or connector |
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B2229 is not output |
| DTC B2229 is output |
DTC B2229 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC B2229 is output
Disconnect the U19 multiplex network door ECU connector.
Disconnect the U20 power back door unit assembly set RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U19-2 (BD+2) - U20-1 (BD+2) | Always | Below 1 Ω |
| U19-1 (BD-2) - U20-2 (BD-2) | Always | Below 1 Ω |
| U19-2 (BD+2) or U20-1 (BD+2) - Body ground | Always | 10 kΩ or higher |
| U19-1 (BD-2) or U20-2 (BD-2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the power back door unit assembly set RH with a new or normally functioning one.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR DRIVE UNIT>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B2229 is not output |
| DTC B2229 is output |
DTC B2229 is not output
DTC B2229 is output