Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050506 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 89174A 3.REMOVE FRONT AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Disconnect the connector from the front airbag sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)

B340847C01
4.365,0.917 4.833,0.573 true 3.26,1.573 3.729,1.229 true 4.052,0.625 4.271,0.427 true 4.865,0.448 5.177,0.604 0.313,0.156 10 *1 3.104,1.531 3.417,1.688 0.313,0.156 10 *2 4.208,0.25 4.458,0.458 0.25,0.208 10 (A)
*1 Housing Lock *2 Outer Housing



ii.

Push the housing lock again and disconnect the connector.

NOTICE:

Do not push the connector housing part (A) when disconnecting the sensor connector.



iii.

After disconnecting the connector, check that the position of the housing lock is correct as shown in the illustration.

B340848C01
4.698,0.635 5.01,0.792 0.313,0.156 10 *a 1.49,1.885 1.802,2.042 0.313,0.156 10 *b 1.479,0.677 1.792,0.833 0.313,0.156 10 *a 4.74,1.885 5.052,2.042 0.313,0.156 10 *b
*a Incorrect *b Correct




d.
B339276

Remove the bolt and front airbag sensor LH.

NOTICE:

Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.