Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050509 AIRBAG CUT-OFF SWITCH A

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the front passenger side of RHD and LHD vehicles.

·

The procedures listed below are for the front passenger side of LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 69065 3.REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.
B339280C01
2.292,1.354 2.667,1.427 true 1.104,1.302 0.896,0.99 true 0.75,0.813 1.063,0.969 0.313,0.156 10 *1 2.708,1.344 3.021,1.5 0.313,0.156 10 *1
*1 Protective Tape


Put protective tape around the airbag cut off switch cylinder sub-assembly.


b.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.



c.

Disconnect the connector to remove the airbag cut off switch cylinder sub-assembly.