Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050509 AIRBAG CUT-OFF SWITCH A

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the front passenger side of RHD and LHD vehicles.

·

The procedures listed below are for the front passenger side of LHD vehicles.



PROCEDURE

Hide 69065 1.INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.

Connect the connector.


b.

Attach the 2 claws to install the airbag cut off switch cylinder sub-assembly.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION