1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
86309E
4.REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY
86300
5.REMOVE WITH HOLDER ANTENNA ASSEMBLY
Disconnect the connector.
Remove the nut.
Detach the 2 claws and remove the with holder antenna assembly.