Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type)
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050511 FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the driver side of RHD and LHD vehicles.

·

The procedures listed below are for the driver side of LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 73960A 4.REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger without door airbag assembly, keep the airbag deployment side facing upward.


a.
B339291

Remove the 2 screws.


b.

While bending the front of the airbag door, detach the 3 hooks.


c.

Detach the 3 hooks from the rear of the airbag door to remove the instrument panel passenger without door airbag assembly.


Hide 82142A 5.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B339292C01
1.333,0.333 1.74,0.938 true 0.969,2.615 1.292,2.385 true 1.208,0.156 1.521,0.313 0.313,0.156 10 *1 1.292,2.26 1.604,2.417 0.313,0.156 10 *2
*1 Protective Tape
*2 Connector Lock


Detach the connector clamp.


b.

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.


c.

Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger without door airbag assembly.

CAUTION:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.