Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type)
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050511 FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY(for Single Type)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the driver side of RHD and LHD vehicles.

·

The procedures listed below are for the driver side of LHD vehicles.



PROCEDURE

Hide 82142A 1.INSTALL NO. 2 INSTRUMENT PANEL WIRE

a.
B339293C01
2.667,2.604 2.938,2.417 true 2.927,2.302 3.24,2.458 0.313,0.156 10 *1
*1 Connector Lock


Connect the airbag connector to the instrument panel passenger without door airbag assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



b.

Push in the connector lock to install the airbag connector.


c.

Attach the connector clamp to install the No. 2 instrument panel wire to the instrument panel passenger without door airbag assembly.


Hide 73960A 2.INSTALL INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

a.

Attach the 3 rear hooks of the instrument panel passenger without door airbag assembly to the rear of the airbag door.


b.

Push in the instrument panel passenger without door airbag assembly to attach the 3 front hooks to the front of the airbag door.


c.

Install the instrument panel passenger without door airbag assembly with the 2 screws.


Hide 55302A 3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION