Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0050589 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64309A 1.REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)

Hide 64910N 2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 3.REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire, for Compact Spare Tire)

Hide 58410B 4.REMOVE DECK BOARD ASSEMBLY (w/ Full Size Spare Tire)

Hide 64997 5.REMOVE DECK FLOOR BOX LH

Hide 58386 6.REMOVE REAR FLOOR FINISH PLATE (w/o Spare Tire, for Compact Spare Tire)

Hide 64716P 7.REMOVE REAR DECK TRIM COVER (w/ Full Size Spare Tire)

Hide 58577E 8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

a.

w/o Spare Tire, for Compact Spare Tire:

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL



Hide 67918E 10.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332C 11.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 64740E 12.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 13.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E270053

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E270054

Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.


d.

Using a screwdriver, bend back and break off the claw as shown in the illustration.

E270055


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.