Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 2AR-FE)
RM3090E _52 Drivetrain _008754 CLUTCH _0050753 CLUTCH UNIT(for 2AR-FE) A

CLUTCH  CLUTCH UNIT(for 2AR-FE)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.


PROCEDURE

Hide 2.REMOVE CLUTCH TUBE

a.
C277988N01
0.375,0.344 0.531,0.542 0.156,0.198 10 A 2.604,0.76 2.76,0.958 0.156,0.198 10 A 2.625,1.177 2.781,1.375 0.156,0.198 10 B

Using a 10 mm union nut wrench, loosen the bleeder to accumulator tube labeled A and accumulator to flexible hose tube labeled B.


b.

Remove the bolt, clamp, bleeder to accumulator tube and accumulator to flexible hose tube.


Hide 31407B 3.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

C199329

a.

Using a union nut wrench, disconnect the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.


b.

Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle assembly.


Hide 31400 4.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

a.
C226304

Remove the clutch tube boot from the manual transaxle assembly.


b.
C199287

Using a union nut wrench, remove the clutch release cylinder to flexible hose tube from the clutch release with bearing cylinder assembly.


c.
C226305

Remove the 3 bolts and clutch release with bearing cylinder assembly together with the clutch release cylinder to flexible hose tube.


Hide 31210 5.REMOVE CLUTCH COVER ASSEMBLY

C280395
1.135,1.219 0.448,1.583 0.448,1.583 1.188,1.26 true 0.292,1.573 0.479,1.771 0.188,0.198 10 *a 0.771,1.625 0.927,1.823 0.156,0.198 10 5 1.219,1.927 1.375,2.125 0.156,0.198 10 2 1.875,1.813 2.031,2.01 0.156,0.198 10 4 2.521,0.646 2.677,0.844 0.156,0.198 10 6 1.833,0.042 1.99,0.24 0.156,0.198 10 1 0.917,0.531 1.073,0.729 0.156,0.198 10 3
*a Matchmark


a.

Put matchmarks on the clutch cover assembly and flywheel sub-assembly.


b.

Loosen each set bolt one turn at a time in the order shown in the illustration until the spring tension is released.


c.

Remove the set bolts and pull off the clutch cover assembly.

NOTICE:

Do not drop the clutch disc assembly.



Hide 31250 6.REMOVE CLUTCH DISC ASSEMBLY