Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › 2012.12–2013.11
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0050790 LANE DEPARTURE ALERT SWITCH A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 83950M 1.INSTALL TELLTALE LIGHT ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.

Connect the connector.


b.

Attach the claw and 2 clips to install the telltale light assembly (lane departure alert switch).


Hide 55412C 2.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION