Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55412C
3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
83950M
4.REMOVE TELLTALE LIGHT ASSEMBLY
55670
5.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
6.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
55521C
7.REMOVE STEREO OPENING COVER (w/o Audio)
86120
8.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
86804A
9.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
86652A
10.REMOVE SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)
Detach the clamp.
Disconnect the connector and remove the skid control buzzer (lane departure alert buzzer).