The ECM uses each solenoid to perform gear ratio changes and control line pressure. Shift solenoid valves DS1 and DS2 control gear ratio changes. Shift solenoid valve SLS controls belt clamping pressure.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0746 | Pressure Control Solenoid "A" Performance (Shift Solenoid Valve DS1) | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The engine is warmed up, and with the shift lever in D, the vehicle is accelerating. 2.
The actual gear ratio is higher than the target. 3.
2 seconds 4.
2 trip detection logic 1.
The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped. 2.
The actual gear ratio is lower than the target. 3.
1 second 4.
2 trip detection logic |
Continuously variable transaxle assembly | Comes on | DTC stored |
| P0776 | Pressure Control Solenoid "B" Performance (Shift Solenoid Valve DS2) | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The engine is warmed up, and with the shift lever in D, the vehicle is decelerating or stopped. 2.
The actual gear ratio is lower than the target. 3.
1 second 4.
2 trip detection logic 1.
The engine is warmed up, and with the shift lever in D, the vehicle is accelerating. 2.
The actual gear ratio is higher than the target. 3.
2 seconds 4.
2 trip detection logic |
Continuously variable transaxle assembly | Comes on | DTC stored |
The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the problem, illuminates the MIL and stores the DTC.
Perform initialization when parts related to the continuously variable transaxle are replaced.
Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the GTS.
| Proceed to |
|---|
| Only P0746 and P0776 are output |
| P0746 or P0776 and other DTCs are output |
If any other DTCs besides P0746 and P0776 are output, perform troubleshooting for those DTCs first.
Only P0746 and P0776 are output
P0746 or P0776 and other DTCs are output
Replace the continuously variable transaxle assembly.
Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT