The generator control ECU assembly and generator assembly detect reception errors respectively. The generator assembly reception error detected by the generator assembly is sent to the generator control ECU assembly via LIN communication. If an error occurs in the generator control ECU assembly or generator assembly, the generator control ECU assembly determines there is a LIN communication error and stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P161A | LIN Communication Error with Alternator | A reception error in the generator control ECU assembly or generator assembly continues for approximately 17 minutes or more with the ignition switch ON
(1 trip detection logic) |
·
Wire harness or connector ·
Generator assembly ·
Generator control ECU assembly |
Come on | DTC stored |
Check the charging system.
Click herePower Source / Network>3ZR-FAE BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the A58 generator control ECU assembly connector.
Disconnect the B62 generator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-6 (LIN1) - B62-1 (LIN) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A58-6 (LIN1) or B62-1 (LIN) - Body ground | Ignition switch off
(while LIN communication is stopped) |
10 kΩ or higher |
| Result |
|---|
| OK |
| NG |
OK
NG
Inspect the generator assembly.
Click herePower Source / Network>3ZR-FAE BATTERY / CHARGING>GENERATOR>INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG