1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
51443C
4.REMOVE REAR ENGINE UNDER COVER RH
11212
5.REMOVE NO. 2 CYLINDER HEAD COVER
16361A
6.REMOVE V-RIBBED BELT
27020
7.REMOVE GENERATOR ASSEMBLY
Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Disconnect the connector and detach the wire harness clamp.
Remove the 2 bolts and adjusting bar.
Remove the bolt and generator.
Remove the bolt and wire harness clamp bracket.