*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault in the GTS, inspect the DLC3.
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>DTC CHECK / CLEAR
Check for freeze frame data.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>FREEZE FRAME DATA
Record or print DTCs and freeze frame data if necessary.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs and freeze frame data.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Switch the ECM from normal mode to check mode.
Refer to Check Mode Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
If the engine does not start, first perform the "Check DTC" procedure and "Conduct Basic Inspection" procedure below.
| Result | Proceed to |
|---|---|
| Malfunction does not occur | A |
| Malfunction occurs | B |
A
B
Refer to Symptom Simulation.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Refer to DTC Check / Clear.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| Trouble code output | A |
| Trouble code is not output | B |
A
B
Refer to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
Conduct basic inspection.
Refer to Basic Inspection.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>BASIC INSPECTION
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Malfunctioning circuit confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Check the ECM power source circuit.
Refer to ECM Power Source Circuit.
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunction not confirmed | A |
| Malfunction confirmed | B |
A
B
Check for intermittent problems.
Refer to Check for Intermittent Problems.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT