Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0048750 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  Brake Warning Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and CVT oil pressure calibration (for continuously variable transaxle).

K111: Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

K111F: Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

2.CHECK BRAKE WARNING LIGHT

DTC is output

2.CHECK BRAKE WARNING LIGHT
a.

Disconnect the A63 skid control ECU (brake actuator assembly) connector.


b.

Turn the ignition switch to ON.


c.

Check that the brake warning light comes on.


OK:

The brake warning light comes on.


Result:
Proceed to
OK
NG



OK

NG

3.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)
3.PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)
a.

Turn the ignition switch off.


b.

Reconnect the A63 skid control ECU (brake actuator assembly) connector.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.


g.

According to the display on the GTS, perform the Active Test.


Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Brake Warning Light Brake warning light Warning light OFF/ON Observe combination meter
Vehicle condition: Vehicle stopped
h.

When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.


Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Brake Warning Light Brake warning light OFF or ON OFF: Warning light off
ON: Warning light on
-
Chassis > ABS/VSC/TRC > Active Test
Active Test Display
Brake Warning Light
Data List Display
Brake Warning Light
50004 105 12 52
Result:
Result Proceed to
Brake warning light in the Data List does not change using the Active Test A
Brake warning light in the Data List turns ON/OFF using the Active Test B



A

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Turn the ignition switch off.


b.

Perform Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Brake
50004 122 21

c.

Check the combination meter assembly.


OK:

The brake warning light turns on or off in accordance with the GTS.


Result:
Proceed to
OK
NG



OK

NG