Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › ECD SYSTEM › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0058550 ECD SYSTEM C

1AD-FTV ENGINE CONTROL  ECD SYSTEM  P2226  Barometric Pressure Circuit  P2228  Barometric Pressure Circuit Low Input  P2229  Barometric Pressure Circuit High Input  


DESCRIPTION

To detect atmospheric pressure, the built in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2226 Barometric Pressure Circuit Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic). ECM Comes on DTC stored
P2228 Barometric Pressure Circuit Low Input Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic). ECM Comes on DTC stored
P2229 Barometric Pressure Circuit High Input Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic). ECM Comes on DTC stored

Related Data List
DTC No. Data List
P2226
·

Atmosphere Pressure

·

MAP


P2228
P2229

HINT:
·

When the ignition switch is ON, the intake manifold pressure "MAP" is approximately equal to atmospheric pressure.

·

Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in altitude, pressure drops by 1 kPa. Varies by weather (high atmospheric pressure, low atmospheric pressure).

·

If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:

·

Misfire

·

Combustion noise

·

Black smoke

·

White smoke




CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P2226 Ignition switch ON for 1 second
P2228
P2229

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 61

d.

Turn the ignition switch off and wait for 30 seconds.


e.

Turn the ignition switch to ON and wait for 1 second or more.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


h.

Confirm that the DTC is not output.

Powertrain > Engine > Trouble Codes
50001 61

Result:
Proceed to
NEXT



NEXT

END