The soak timer measures the engine off soak time, which is the time elapsed after the ignition switch has been turned off. The ECM uses the engine off soak time to monitor some systems for malfunction detection.
If necessary, the soak timer may activate the ECM to perform certain malfunction checks that can only be performed after the engine stopped. The soak timer is built into the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2610 | ECM / PCM Internal Engine Off Timer Performance | ECM internal malfunction (2 trip detection logic). | ECM | Comes on | DTC stored |
While the engine is running, the ECM monitors the synchronization of the soak timer and the CPU clock. If these two are not synchronized, the ECM interprets this as a malfunction, illuminates the MIL and stores the DTC.
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).
DTC P2610 is stored if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is necessary.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Replace the ECM.
Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Start the engine and wait for 10 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
If no pending DTC is output, the repair has been successfully completed.
| Proceed to |
|---|
| NEXT |
NEXT