For more information on the DPNR*1 catalytic converter and TOYOTA D-CAT*2, refer to the following procedures (Click here Engine / Hybrid System>2AD-FHV ENGINE CONTROL>ECD SYSTEM>SYSTEM DESCRIPTION).
*1: Diesel Particulate NOx Reduction System
*2: Diesel Clean Advanced Technology
If P2002 is present, refer to the DTC table for TOYOTA D-CAT (Click here Engine / Hybrid System>2AD-FHV ENGINE CONTROL>ECD SYSTEM>SYSTEM DESCRIPTION).
The DPNR catalyst has the ability to reduce particulate matter (PM), hydrocarbons (HC), carbon monoxides (CO) and nitrogen oxides (NOx). The DPNR catalyst is a monolithic type catalyst. Alternating passages in the catalyst have either their inlet or outlet blocked. This forces the exhaust gasses to flow through the walls of the passages (see illustration). Due to the flow of the exhaust gases through microcavities in the passage walls, it is called a "wall-flow" type converter.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2002 | Particulate Trap Efficiency Below Threshold (Bank1) | The Catalyst Record exceeds the threshold (Thermal deterioration malfunction)
(1 trip detection logic). |
DPNR catalytic converter (Exhaust manifold converter sub-assembly) | Comes on | DTC stored |
| DTC No. | Data List |
|---|---|
| P2002 | DPF Thermal Deteriorate |
In order to detect abnormality in the DPNR catalyst, the ECM monitors the exhaust gas temperature as well as differential pressure in front of and behind the DPNR catalyst.
Furthermore, the ECM calculates and integrates the Catalyst Record of catalyst thermal deterioration data with the catalyst temperature. If Catalyst Record exceeds the threshold, the ECM interprets this as a malfunction in the DPNR catalyst and illuminates the MIL.
After replacing the exhaust manifold converter sub-assembly (DPNR catalyst), clear the thermal deterioration data stored in the ECM.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
When the DPNR catalytic converter (Exhaust manifold converter sub-assembly) is replaced, the catalyst record of DPF thermal deterioration stored in the ECM must be cleared.
Replace the DPNR catalytic converter (Exhaust manifold converter sub-assembly).
Click hereEngine / Hybrid System>2AD-FHV EMISSION CONTROL>MONOLITHIC CONVERTER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the menu options in this order: Powertrain / Engine / Utility / Catalyst Record Clear.
| Tester Display |
|---|
| Catalyst Record Clear |
| Proceed to |
|---|
| NEXT |
NEXT