45130
1.INSTALL STEERING PAD ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Support the steering pad assembly with one hand.
| *1 | Airbag Connector |
| *2 | Connector Lock |
| *3 | Horn Connector |
Connect the 2 airbag connectors to the steering pad assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the 2 connector locks to install the 2 airbag connectors.
Connect the horn connector to the steering pad assembly.
Attach the 3 claws to install the steering pad assembly.
Attach the 3 claws by pushing the steering pad assembly.
Make sure that the steering pad assembly is securely installed.
45186
2.INSTALL LOWER NO. 2 STEERING WHEEL COVER
Attach the guide and claw to install the lower No. 2 steering wheel cover.
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45130
4.INSPECT STEERING PAD ASSEMBLY
With the steering pad assembly installed to the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad assembly with a new one:
Cuts, minute cracks or marked discoloration on the steering pad assembly top surface or in the grooved portion.
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
Click hereVehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE
5.PERFORM DIAGNOSTIC SYSTEM CHECK
6.CHECK SRS WARNING LIGHT