The ECM controls the signal sent to shift solenoid valve DSU and performs lock-up clutch pressure control in response to the input torque value.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2763 | Torque Converter Clutch Pressure Control Solenoid Control Circuit High (Shift Solenoid Valve DSU) | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The vehicle is being driven. 2.
There is an open circuit in the shift solenoid valve DSU circuit. 3.
Detected 20 times or more consecutively 4.
1 trip detection logic |
·
Open in shift solenoid valve DSU circuit ·
Continuously variable transaxle assembly ·
ECM |
Comes on | DTC stored |
| P2764 | Torque Converter Clutch Pressure Control Solenoid Control Circuit Low (Shift Solenoid Valve DSU) | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The vehicle is being driven. 2.
There is a short circuit in the shift solenoid valve DSU circuit. 3.
Detected 20 times or more consecutively 4.
1 trip detection logic |
·
Short in shift solenoid valve DSU circuit ·
Continuously variable transaxle assembly ·
ECM |
Comes on | DTC stored |
These DTCs indicate an open or short circuit in the shift solenoid valve DSU circuit. The ECM controls lock-up by turning shift solenoid valve DSU on/off. When there is an open or short circuit in the shift solenoid valve DSU circuit, the ECM detects the problem, illuminates the MIL and stores the DTC.
Perform initialization when parts related to the continuously variable transaxle are replaced.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
| *a | Component without harness connected
(Transmission Wire) |
Disconnect the transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (DSU) - Body ground | 20°C (68°F) | 11 to 13 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B75-71 (DSU) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the ECM.
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Replace the continuously variable transaxle assembly.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT